The present study is devoted to the determination of the optimal parameters and characteristics of a three degree of freedom dynamic vibration absorber (3 DOF DVA) for the vibration reduction of a plate at a given point. The optimization scheme uses simulated annealing and constrained simulated annealing, which is capable of optimizing systems with a set of constraints. Comparisons between a 3 DOF DVA and multiple (5) 1 DOF DVAs show a better performance of the former for vibration reduction. Regarding the characteristics of the optimal 3 DOF DVA, numerical tests reveal that the absorber is robust under variations of the observation point and for 10% variations of its mass, stiffness and damping. From the analysis of parameter changes of the plate, it is found that the optimal 3 DOF DVA is almost insensitive to a mass change, and sensitive to a change of Young’s modulus for low frequencies. In this case, a decrease in Young’s modulus causes a decrease in its effectiveness, and an increase improves it. The study of the effect of the 3 DOF DVA location on its effectiveness reveals that the requirements of closeness of the absorber to an antinode of the bare primary structure and to the observation point improve its performance. Additionally, for a rotational mode of the 3-DOF DVA about some axis, the effectiveness of the absorber at a given frequency can be notably increased if it is located at a position of the primary system with an in-phase or out-of- phase motion of the attachment points according to the rotational-mode characteristics of the 3-DOF DVA at this frequency.
Skip Nav Destination
e-mail: mfebbo@uns.edu.ar
Article navigation
April 2012
Research Papers
Optimal Parameters and Characteristics of a Three Degree of Freedom Dynamic Vibration Absorber
Mariano Febbo
Mariano Febbo
Instituto de Física del Sur (IFISUR) and CONICET Departmento de Física,
e-mail: mfebbo@uns.edu.ar
Universidad Nacional del Sur
, Bahía Blanca 8000, Argentina
Search for other works by this author on:
Mariano Febbo
Instituto de Física del Sur (IFISUR) and CONICET Departmento de Física,
Universidad Nacional del Sur
, Bahía Blanca 8000, Argentina
e-mail: mfebbo@uns.edu.ar
J. Vib. Acoust. Apr 2012, 134(2): 021010 (11 pages)
Published Online: January 18, 2012
Article history
Received:
April 5, 2010
Revised:
April 13, 2011
Online:
January 18, 2012
Published:
January 18, 2012
Citation
Febbo, M. (January 18, 2012). "Optimal Parameters and Characteristics of a Three Degree of Freedom Dynamic Vibration Absorber." ASME. J. Vib. Acoust. April 2012; 134(2): 021010. https://doi.org/10.1115/1.4004667
Download citation file:
Get Email Alerts
Related Articles
A State-Switched Absorber Used for Vibration Control of Continuous Systems
J. Vib. Acoust (October,2007)
Optimization of a Two Degree of Freedom System Acting as a Dynamic Vibration Absorber
J. Vib. Acoust (February,2008)
Optimization of Dynamic Vibration Absorbers for Suppressing Sound Radiation of Plate Structures
J. Vib. Acoust (April,2021)
On the Proper Orthogonal Modes and Normal Modes of Continuous Vibration Systems
J. Vib. Acoust (January,2002)
Related Proceedings Papers
Related Chapters
The Effect of the Annealing Schedule on Simulated Annealing for Function Optimization and Fuel Cell Design
Intelligent Engineering Systems through Artificial Neural Networks, Volume 20
MIDRS: A Metaheuristic Based on Deterministic Finite Automata and Simulated Annealing Technique for Biobjective Optimization Combinatorial Problems
International Conference on Computer and Computer Intelligence (ICCCI 2011)
Solving Nonlinear Programming Problems via Advanced Simulated Annealing
International Conference on Advanced Computer Theory and Engineering (ICACTE 2009)