Skip Nav Destination
Article navigation
October 1976
This article was originally published in
Journal of Lubrication Technology
Discussions
Discussion: “The Lubrication of Lightly Loaded Cylinders in Combined Rolling, Sliding, and Normal Motion—Part II: Experimental” (Markho, P. H., and Dowson, D., 1976, ASME J. Lubr. Technol., 98, pp. 517–522)
James J. Kauzlarich
James J. Kauzlarich
Dept. of Mechanical Engineering, University of Virginia, Charlottesville, Va.
Search for other works by this author on:
James J. Kauzlarich
Dept. of Mechanical Engineering, University of Virginia, Charlottesville, Va.
J. of Lubrication Tech. Oct 1976, 98(4): 522-523 (2 pages)
Published Online: October 1, 1976
Article history
Online:
October 20, 2010
Connected Content
Citation
Kauzlarich, J. J. (October 1, 1976). "Discussion: “The Lubrication of Lightly Loaded Cylinders in Combined Rolling, Sliding, and Normal Motion—Part II: Experimental” (Markho, P. H., and Dowson, D., 1976, ASME J. Lubr. Technol., 98, pp. 517–522)." ASME. J. of Lubrication Tech. October 1976; 98(4): 522–523. https://doi.org/10.1115/1.3452910
Download citation file:
191
Views
Get Email Alerts
Cited By
Related Articles
Piston Ring-Cylinder Bore Friction Modeling in Mixed Lubrication Regime: Part II—Correlation With Bench Test Data
J. Tribol (January,2001)
Piston Ring-Cylinder Bore Friction Modeling in Mixed Lubrication Regime: Part I—Analytical Results
J. Tribol (January,2001)
Flow Factors for Lubrication With Emulsions in Ironing
J. Tribol (April,2001)
Tri-Axial Force Measurements on the Cylinder of a Motored SI Engine Operated on Lubricants of Differing Viscosity
J. Eng. Gas Turbines Power (September,2010)
Related Proceedings Papers
Related Chapters
Tribology of Hydraulic Systems: Hydrodynamic Effects of Surface Roughness
Hydraulic Failure Analysis: Fluids, Components, and System Effects
An Experimental Comparison of the In-Air and Underwater Damping Properties of Composite Cylinders
M3D III: Mechanics and Mechanisms of Material Damping
Experimental Investigation of Mortar Compressive Strength Using 5.08 cm. Cubes and 7.62 cm. × 15.24 cm. Cylinders
Masonry: Components to Assemblages