Solid-desiccant dehumidifiers are increasingly becoming an integral part of desiccant based air-conditioning systems because of their effective handling of latent heat loads compared to conventional vapor compression units. In these units, either a silica gel or a molecular sieve is used for dehumidification of air. Both of them have the capability to co-adsorb various chemical pollutants during dehumidification of air. However, the shape of the isotherm for water vapor on these materials is not favorable for desiccant cooling applications. A mixture (IM desiccant) containing a silica gel, a molecular sieve, and a hydrophobic molecular sieve that was coated on an aluminum foil was studied for its capability for simultaneous removal of moisture and some selected pollutants from air. Experimental data were obtained in a fixed bed adsorber that simulated the operation of a rotary desiccant wheel. Air to be dehumidified and cleaned and the hot regeneration air were cycled in a specific time interval through this bed. The shape of the water isotherm on IM desiccant was found to be in between that of silica gel and molecular sieve 13×, but its uptake capacity was significantly lower than that of either silica gel or molecular sieve. A flow rate of about 100 L/min that provided a face velocity of about 132 cm/s was used in the adsorption step. The flow rate during regeneration was about 50 L/min. The temperature of the inlet air was about 23°C and its relative humidity was varied between 20 percent and 80 percent. The concentrations of pollutants were as follows; carbon dioxide: 1050 and 2300 ppm; toluene: 32 ppm; 1,1,1-trichloroethane: 172 ppm, and formaldehyde: 0.35 ppm. A complete breakthrough of all the pollutants was observed during an adsorption cycle. However, a removal efficiency greater than 50 percent for these pollutants was observed if the adsorption cycle time was about 1 minute.

Issue Section:
Research Papers
Topics:
Dehumidification, Pollution, Wheels, Cycles, Flow (Dynamics), Shapes, Air conditioning, Aluminum foil, Carbon dioxide, Compression, Cooling, Dehumidifiers, Latent heat, Stress, Temperature, Vapors, Water, Water vapor
1.
Babu, J. C, “Adsorption of CO2, Water Vapor, Toluene, and 1,1,1-Trichloroethane in a Fixed Bed of Silica Gel, Molecular Sieve, and Activated Carbon,” M.S. Thesis, University of Missouri-Columbia, Columbia, Missouri, 1991.
2.
Collier, R. K., “Advanced Desiccant Materials Assessment,” Phase 2, Report No. GRI-88/0I25, Gas Research Institute, Chicago, IL, 1988.
3.
Collier
 
R. K.
, and
Cohen
 
B. M.
, “
An Analytical Examination of Methods for Improving the Performance of Desiccant Cooling Systems
,”
ASME JOURNAL OF SOLAR ENERGY ENGINEERING
, Vol.
113
, p.
157
157
, August
1991
.
4.
Collier, R. K., “Desiccant Properties and their Effect on Cooling System Performance,” ASHRAE Trans., p. 823, 1986.
5.
Gauger, D. C, Shapiro, H. N., and Pate, M. B., “Alternative Technologies for Refrigeration and Air-Conditioning Applications,” Report No. EPA/600/SR-95/ 066, US EPA, Air and Energy Engineering Research Laboratory Research Triangle Park, NC, May 1995.
6.
Harriman, L. G., The Dehumidification Handbook, 2nd Ed., Munters Cargocaire, Amesbury, MA, 1990.
7.
Harriman, L. G., The Basics of Commercial Desiccant Systems, Heating/Piping/Air Conditioning, p. 77, July, 1994.
8.
Hassan N. M., Co-Adsorption of Radon and Water-Vapor Mixtures on BPL Activated Carbon and Solid Desiccants,” Ph. D. Dissertation, University of Missouri-Columbia, 1990.
9.
Hines, A. L. and Ghosh, T. K., “Water Vapor Uptake and Removal of Chemical Pollutants by Solid Adsorbents, Gas Research Institute, ” Chicago, IL, Report No. GRI-92/0157.2, NTIS No. PB95-104691, 1992.
10.
Hines, A. L., Ghosh, T. K., Loyalka, S. K., and Warder, R. C, Indoor Air: Quality and Control, Prentice Hall, N.J., 1993.
11.
Husky, B., “Advanced Solar/Gas Desiccant Cooling System,” Gas Research Institute, Chicago, IL, Contract 5081-343-0477, 1982.
12.
Leu, S. W., “Co-Adsorption of Indoor Air Pollutants in the Presence of Water Vapor on Solid Adsorbents,” M.S. Thesis, University of Missouri-Columbia , Columbia, Missouri, 1992.
13.
Perry, R. H. and Green, D. W., and Maloney, J. O., Chemical Engineering Handbook, McGraw Hill, New York, 6th ed., 1984.
14.
Raghavan
 
V.
and
Gidaspow
 
D.
, “
Diffusion and Adsorption of Moisture in Desiccant Sheets
,”
AIChE J.
, Vol.
31
(
11
), p.
1791
1791
,
1985
.
15.
Schlepp , D., and Barlow, R., “Performance of the SERI Parallel-Passage Dehumidifier,” NTIS SERI/tr-252-1951, Solar Energy Research Institute, Golden, CO, 1984.
16.
Lee, S-Y., “Adsorption of Moisture and Indoor Pollutants on a Mixed Adsorbent, ” Ph.D. Thesis, University of Missouri-Columbia, Columbia, MO., 1997.
17.
Zheng
 
W.
,
Worek
 
W. M.
, and
Novosel
 
D.
, “
Performance Optimization of Rotary Dehumidifiers
,”
ASME JOURNAL OF SOLAR ENERGY ENGINEERING
, Vol.
117
, p.
40
40
,
1995
.
This content is only available via PDF.
Copyright © 1999
 by The American Society of Mechanical Engineers
You do not currently have access to this content.