We conducted experiments on the effect of dissolving three different salts sodium chloride (NaCl), sodium sulfate and magnesium sulfate in water droplets boiling on a hot stainless steel surface. Substrate temperatures were varied from 90°C to 220°C. We photographed droplets as they evaporated, and recorded their evaporation time. At surface temperatures that were too low to initiate nucleate boiling all three salts were found to reduce droplet evaporation rates because they lower the vapor pressure of water. In the nucleate boiling regime, low concentrations (<0.1 mol/l) of and enhanced heat transfer because they prevented coalescence of vapor bubbles and produced foaming in the droplet, significantly reducing droplet lifetimes. Increasing the salt concentration further did not produce a corresponding increase in droplet boiling rate. Dissolved salts prevent bubble coalescence because they increase surface tension and stabilize the liquid film separating bubbles, and because electric charge that accumulates on the surfaces of bubbles produces a repulsive force, preventing them from approaching each other. and which have high ionic strengths, produced a large amount of foaming in droplets and increased their boiling rate significantly. NaCl, which has low ionic strength, had little effect on droplet boiling.
Skip Nav Destination
e-mail: chandra@mie.utoronto.ca
Article navigation
Technical Papers
The Effect of Dissolving Salts in Water Sprays Used for Quenching a Hot Surface: Part 1—Boiling of Single Droplets
Qiang Cui,
Qiang Cui
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario M5S 3G8, Canada
Search for other works by this author on:
Sanjeev Chandra,
e-mail: chandra@mie.utoronto.ca
Sanjeev Chandra
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario M5S 3G8, Canada
Search for other works by this author on:
Susan McCahan
Susan McCahan
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario M5S 3G8, Canada
Search for other works by this author on:
Qiang Cui
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario M5S 3G8, Canada
Sanjeev Chandra
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario M5S 3G8, Canada
e-mail: chandra@mie.utoronto.ca
Susan McCahan
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario M5S 3G8, Canada
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division February 27, 2002; revision received October 7, 2002. Associate Editor: D. B. R. Kenning.
J. Heat Transfer. Apr 2003, 125(2): 326-332 (7 pages)
Published Online: March 21, 2003
Article history
Received:
February 27, 2002
Revised:
October 7, 2002
Online:
March 21, 2003
Citation
Cui , Q., Chandra, S., and McCahan, S. (March 21, 2003). "The Effect of Dissolving Salts in Water Sprays Used for Quenching a Hot Surface: Part 1—Boiling of Single Droplets ." ASME. J. Heat Transfer. April 2003; 125(2): 326–332. https://doi.org/10.1115/1.1532010
Download citation file:
Get Email Alerts
Cited By
Estimation of thermal emission from mixture of CO2 and H2O gases and fly-ash particles
J. Heat Mass Transfer
Non-Classical Heat Transfer and Recent Progress
J. Heat Mass Transfer
Related Articles
The Effect of Dissolving Salts in Water Sprays Used for Quenching a Hot Surface: Part 2—Spray Cooling
J. Heat Transfer (April,2003)
The Effect of Dissolving Gases or Solids in Water Droplets Boiling on a Hot Surface
J. Heat Transfer (August,2001)
Flow Visualization of Submerged Steam Jet in Subcooled Water
J. Heat Transfer (February,2016)
Thin-Film Evaporation in an Evaporating Droplet
J. Heat Transfer (August,2009)
Related Proceedings Papers
Related Chapters
Numerical Simulation of Nucleate Spray Cooling: Effect of Droplet Impact on Bubble Growth and Heat Transfer in a Thin Liquid Film
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)
Energy Balance for a Swimming Pool
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
A New Boom Mechanism Design for Corn Sprayer
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)