1-8 of 8
Keywords: Vaporization
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. September 2018, 140(9): 092808.
Paper No: GTP-18-1104
Published Online: July 30, 2018
... 100 0 Cetane number 11–19 53–54 Lower heating value (kJ/g) 44.3 44.6 Boiling point (°C) 99.2 98.38 Density (kg/m 3 ) (20 °C) 691.9 683.7 Heat of vaporization (kJ/kg) (25 °C/boiling point) 267/308 317/365 The experimental conditions for the experiments of interest...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. September 2018, 140(9): 091202.
Paper No: GTP-17-1383
Published Online: June 15, 2018
... ,” The MathWorks, Inc., Natick, MA. [26] Goodwin , D. G. , 2003 , “ An Open-Source, Extensible Software Suite for CVD Process Simulation ,” Chemical Vapor Deposition XVI and EUROCVD 14 , Paris, France, Apr. 27–May 2, pp. 155 – 162 . https://www.electrochem.org/dl/ma/203/pdfs/2038.pdf [27] Smith...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. September 2018, 140(9): 092802.
Paper No: GTP-18-1083
Published Online: May 24, 2018
... the evaporation enthalpy of the liquid and subsequently weighted by the mass distribution of water vapor similar to calculations shown for the analytical model (see Eqs. (20) and (21) ). Comparing the temperatures measured for OP1 with the temperature profile of Sim1 (Sim1 evap: dashed line) incorporating...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. February 2018, 140(2): 021502.
Paper No: GTP-17-1316
Published Online: October 3, 2017
... was applied to analyze the fuel vapor repartition and local equivalence ratio. Here, ignition was tackled through a probabilistic approach in order to identify the favorable and unfavorable regions inside the combustion chamber for placing a spark to start ignition. The objective of this first section...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. April 2015, 137(4): 041702.
Paper No: GTP-14-1474
Published Online: April 1, 2015
... pressure. The LNG tank is in a constant boiling state. The total BOG flow is a combination of the entire vapor generated from rundown flash, heat leak, barometric pressure changes, pump energy, and net hydraulic grade. If this vapor is not drawn off by the BOG compressor, the tank pressure will increase...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. March 2015, 137(3): 032605.
Paper No: GTP-14-1359
Published Online: October 14, 2014
... Mass Transfer Multiphase flows Phase change Sprays Two-phase Vaporization Fogging techniques turned into a common method of increasing or regulating gas turbines power output. The technique was originally discovered due to temporary thrust increase of aircraft engines during take-off...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. December 2014, 136(12): 121507.
Paper No: GTP-14-1233
Published Online: July 15, 2014
... to heating were on average less than 0.2% of fully saturated values. Possible variations in fuel makeup and density due to the deoxygenation methods are discussed. At the highest fuel temperatures, test conditions with combustion pressures below the vaporization pressure of the fuel led to lower combustion...