Unsteady forces generated by fluid flow through the impeller shroud leakage path of a centrifugal pump were investigated. Different pump shroud geometries were compared, and the effect of leakage path inlet swirl (pump discharge swirl) on the rotordynamic forces was examined for various ratios of fluid throughflow velocity to impeller tip speed. A short axial length leakage path reduced the measured forces, while curvature appeared to increase the destabilizing forces when inlet swirl was present. It was observed that changing the inlet swirl velocity does not appear to significantly affect the measured forces for a given leakage flow coefficient, but any nonzero inlet swirl is destabilizing when compared to cases with no inlet swirl.
Issue Section:
Research Papers
1.
Adkins
D.
Brennen
C.
1988
, “Analysis of Hydrodynamic Radial Forces on Centrifugal Pump Impellers
,” ASME JOURNAL OF FLUIDS ENGINEERING
, Vol. 110
, No. 1
, pp. 20
–28
.2.
Bolleter
U.
Wyss
A.
Welte
I.
Sturchler
R.
1987
, “Measurement of Hydraulic Interaction Matrices of Boiler Feed Pump Impellers
,” ASME Journal of Vibrations, Stress, and Reliability in Design
, Vol. 109
, pp. 144
–151
.3.
Brennen, C., 1994, Hydrodynamics of Pumps, Concepts ETI and Oxford University Press.
4.
Guinzburg, A., 1992, “Rotordynamic Forces Generated By Discharge-to-Suction Leakage Flows in Centrifugal Pumps,” Ph.D. thesis, California Institute of Technology.
5.
Guinzburg
A.
Brennen
C.
Acosta
A.
Caughey
T.
1993
, “The Effect of Inlet Swirl on the Rotordynamic Shroud Forces in a Centrifugal Pump
,” ASME Journal of Engineering for Gas Turbines and Power
, Vol. 115
, No. 2
, pp. 287
–293
.6.
Guinzburg
A.
Brennen
C.
Acosta
A.
Caughey
T.
1994
, “Experimental Results for the Rotordynamic Characteristics of Leakage Flows in Centrifugal Pumps
,” ASME JOURNAL OF FLUIDS ENGINEERING
, Vol. 116
, No. 1
, pp. 110
–115
.7.
Jery, B., 1986, “Experimental Study of Unsteady Hydrodynamic Force Matrices on Whirling Centrifugal Pump Impellers,” Ph.D. thesis, California Institute of Technology.
8.
Sivo
J.
Acosta
A.
Brennen
C.
Caughey
T.
1995
, “The Influence of Swirl Brakes on the Rotordynamic Forces Generated by Discharge-to-Suction Leakage Flows in Centrifugal Pumps
,” ASME JOURNAL OF FLUIDS ENGINEERING
, Vol. 117
, No. 1
, pp. 104
–108
.9.
Tsujimoto
Y.
Yoshida
Y.
Ohashi
H.
Ishizaki
S.
1997
, “Fluid Force Moment on a Centrifugal Impeller in Precessing Motion
,” ASME JOURNAL OF FLUIDS ENGINEERING
, Vol. 119
, No. 2
, pp. 366
–371
.10.
Uy
R.
Bircumshaw
B.
Brennen
C.
1998
, “Rotordynamic Forces from Discharge-to-Suction Leakage Flows in Shrouded Centrifugal Pumps: Effects of Geometry
,” JSME International Journal: Fluids and Thermal Engineering
, Vol. 41
, No. 1
, pp. 208
–213
.
This content is only available via PDF.
Copyright © 1999
by The American Society of Mechanical Engineers
You do not currently have access to this content.