Lifting up a cage with miners via a mining cable causes axial vibrations of the cable. These vibration dynamics can be described by a coupled wave partial differential equation-ordinary differential equation (PDE-ODE) system with a Neumann interconnection on a time-varying spatial domain. Such a system is actuated not at the moving cage boundary, but at a separate fixed boundary where a hydraulic actuator acts on a floating sheave. In this paper, an observer-based output-feedback control law for the suppression of the axial vibration in the varying-length mining cable is designed by the backstepping method. The control law is obtained through the estimated distributed vibration displacements constructed via available boundary measurements. The exponential stability of the closed-loop system with the output-feedback control law is shown by Lyapunov analysis. The performance of the proposed controller is investigated via numerical simulation, which illustrates the effective vibration suppression with the fast convergence of the observer error.
Skip Nav Destination
Article navigation
November 2018
Research-Article
Axial Vibration Suppression in a Partial Differential Equation Model of Ascending Mining Cable Elevator
Ji Wang,
Ji Wang
State Key Laboratory of
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: wangji@cqu.edu.cn
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: wangji@cqu.edu.cn
Search for other works by this author on:
Shumon Koga,
Shumon Koga
Department of Mechanical and
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: skoga@ucsd.edu
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: skoga@ucsd.edu
Search for other works by this author on:
Yangjun Pi,
Yangjun Pi
State Key Laboratory of
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: cqpp@cqu.edu.cn
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: cqpp@cqu.edu.cn
Search for other works by this author on:
Miroslav Krstic
Miroslav Krstic
Fellow ASME
Department of Mechanical and
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: krstic@ucsd.edu
Department of Mechanical and
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: krstic@ucsd.edu
Search for other works by this author on:
Ji Wang
State Key Laboratory of
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: wangji@cqu.edu.cn
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: wangji@cqu.edu.cn
Shumon Koga
Department of Mechanical and
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: skoga@ucsd.edu
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: skoga@ucsd.edu
Yangjun Pi
State Key Laboratory of
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: cqpp@cqu.edu.cn
Mechanical Transmission, and
College of Automotive, Engineering,
Chongqing University,
Chongqing 400044, China
e-mail: cqpp@cqu.edu.cn
Miroslav Krstic
Fellow ASME
Department of Mechanical and
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: krstic@ucsd.edu
Department of Mechanical and
Aerospace Engineering,
University of California, San Diego,
La Jolla, CA 92093-0411
e-mail: krstic@ucsd.edu
Contributed by the Dynamic Systems Division of ASME for publication in the JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT,AND CONTROL. Manuscript received October 10, 2017; final manuscript received May 2, 2018; published online June 4, 2018. Assoc. Editor: Davide Spinello.
J. Dyn. Sys., Meas., Control. Nov 2018, 140(11): 111003 (13 pages)
Published Online: June 4, 2018
Article history
Received:
October 10, 2017
Revised:
May 2, 2018
Citation
Wang, J., Koga, S., Pi, Y., and Krstic, M. (June 4, 2018). "Axial Vibration Suppression in a Partial Differential Equation Model of Ascending Mining Cable Elevator." ASME. J. Dyn. Sys., Meas., Control. November 2018; 140(11): 111003. https://doi.org/10.1115/1.4040217
Download citation file:
Get Email Alerts
Control of a Directional Downhole Drilling System Using a State Barrier Avoidance Based Method
J. Dyn. Sys., Meas., Control (May 2025)
Dynamic control of cardboard-blank picking by using reinforcement learning
J. Dyn. Sys., Meas., Control
Offline and online exergy-based strategies for hybrid electric vehicles
J. Dyn. Sys., Meas., Control
In-Situ Calibration of Six-Axis Force/Torque Transducers on a Six-Legged Robot
J. Dyn. Sys., Meas., Control (May 2025)
Related Articles
Spacecraft Vibration Suppression Using Variable Structure Output Feedback Control and Smart Materials
J. Vib. Acoust (April,2006)
Vibration Suppression in Cutting Tools Using a Collocated Piezoelectric Sensor/Actuator With an Adaptive Control Algorithm
J. Vib. Acoust (October,2010)
An Anti-Windup Design for Linear System With Asymptotic Tracking Subjected to Actuator Saturation
J. Dyn. Sys., Meas., Control (June,2000)
Using Constrained Bilinear Quadratic Regulator for the Optimal Semi-Active Control Problem
J. Dyn. Sys., Meas., Control (November,2017)
Related Proceedings Papers
Related Chapters
Fault-Tolerant Control of Sensors and Actuators Applied to Wind Energy Systems
Electrical and Mechanical Fault Diagnosis in Wind Energy Conversion Systems
QP Based Encoder Feedback Control
Robot Manipulator Redundancy Resolution
Norms of Feedback Systems
Robust Control: Youla Parameterization Approach