The rules for the design of high temperature reactor components in Section III, Division 5, Subsection HB, Subpart B (HBB) of the ASME Boiler and Pressure Vessel Code contain two options for evaluating the deformation-controlled design limits on strain accumulation and creep-fatigue: design by elastic analysis and design by inelastic analysis. Of these options design by inelastic analysis tends to be less overconservative and produce more efficient designs. However, the HBB currently does not provide approved material models for use with the inelastic analysis rules, limiting their widespread use. A nonmandatory appendix has been developed to provide general guidance on appropriate material models and provide reference material models suitable for use with the design by inelastic analysis approach. This paper describes a viscoplastic model for Alloy 617 suitable for use with the HBB rules proposed for incorporation into the new appendix. The model represents the high temperature creep, creep-fatigue, and tensile response of Alloy 617 and accurately accounts for rate sensitivity across a wide range of temperatures. The focus in developing the model was on capturing key features of material deformation required for accurately executing the HBB rules and on developing a relatively simple model form that can be implemented in commercial finite element analysis software. The paper validates the model against an extensive experimental database collected as part of the Alloy 617 Code qualification effort as well as against specialized experimental tests examining the effect of elastic follow up on stress relaxation and creep deformation in the material.